IBM 检查代码含义
Symptom / Error
(开机错误代码)
FRU / Action in Sequence
(检查范围及解决方法)
10X
101: Interrupt failure
;(中断故障)
102: Timer failure
;(计时器故障)
103: Timer interrupt failure
;
(计时器中断故障)
104: Protected mode failure
;
(保护模式故障)
105: Last 8042 command not accepted
;
107: NMI test failure
;(
NMI
测试失败)
108: Timer bus test failure.
109: Low meg-chip select test.
1. System board.
(主板问题)
110
(Planar parity.)
1. Go to
Memory Checkout
2. DIMM card.
3. Detach the expansion unit if it is
attached to the computer.
4. System board.
111
(I/O parity.)
1. Go to
Memory Checkout
2. Expansion unit or port replicator.
3. System board.
11XX
1101
: Serial_A test failure.
(
A
串行口测试失败)
1. Serial device
(串行设备)
2. Communication cable
3. System board
(主板)
12XX
1201
: Serial_B test failure.
(
B
串行口测试失败)
1. System board (infrared)
(检查主板:
红外线口)
158
(Hard disk password was not set even though the
supervisor password is set.)
1. Set the password for hard disk drive.
(设置硬盘密码)
159
(Hard disk password is not set the same as the
supervisor password.)
(硬盘密码与超级用户密码不一
样)
1. Set the correct password for hard
disk drive.
(设置正确的硬盘密码)
161
(Dead battery.)
(
CMOS
1. Go to
Checking the Backup
Battery
2. Backup battery.
(
CMOS
备份电池,在
内存插槽旁边)
3. System board.
(主板)
163
1. Set time and date.
(设置正确的系统时间和日期)
获得更多 -> 维修技巧 -> 维修资料责任编辑: webmaster >>> 百度上搜索 谷歌上搜索
点击复制本连接 (http://www.hugesky.com/showarticle.php?id=6245)>>> 相关资讯:
【声明】: 以上文章或资料除注明为电脑技巧原创或编辑整理外,均为网络收集整理或网友推荐。以上内容以共享、参考、研究为目的,不存在任何商业目的。 未注明作者或出处的文章,可能资料来源不规范。如有涉及版权请给予及时联系更正或予以删除。 |